The material selected for the filter bag is a finer fiber material

Filter bags are a very effective dust removal device. Due to prolonged exposure to various dust, the filter bag is prone to cracking, high temperature, and has a short shelf life. Usually, of course, about 2 years. If properly maintained, it can be used for approximately 4 years. There are many reasons for dust and filter bag damage. Next, the editor would like to share with you the reasons for dust prevention and filter bag damage. This reason is also one of the more issues that users have received over the years.

1： The installation process is not carried out according to specific steps of operation, but is chaotic, and due to the irregular placement of filter bags and cages, it is easy to manufacture dustproof filter bags or cages that need to be compressed until deformed. Deformation leads to poor dust removal effect and easy damage;

2： When installing the filter bag, the verticality of the filter bag is not sufficient. If not vertical, it will inevitably cause friction between the filter bag and the wall panel or filter bag. It is necessary to know that this friction has been present for a long time, so even metal may be damaged, let alone filter bags made of several fibers.

3： The installation of dust prevention and filter bags is not a problem, but there is a deviation in the installation of the blowing pipe. This situation may also occur. Of course, aerosol pressure is too high or frequency is too high. The spray is too high. May be damaged. Even the head of the filter bag is separated from the main body, which is very bad.

The installation of dust prevention and filter bags must be carried out in accordance with conventional and routine procedures. Remember to install debris, which will greatly shorten the lifespan of dust and filter bags, and increase costs.

We know that if the filter bag is abnormal, it must be replaced in a timely manner. If not replaced in a timely manner, it may affect the quality of the filter bag. Therefore, how to replace the filter bag? The next step is to understand the steps for replacing the filter bag.

Firstly, due to the filtration effect of the filter bag, the selected material is a finer fiber material, and the hydrophilicity of these materials is very weak, so the surface will not be wetted by water. Therefore, we need to invite the use of other low surface tension liquids for discussion. Before installation, wet the filter bag and let it sit for a few minutes.

Then, open the upper cover of the filter. When opening the upper cover, ensure that the filtrate has been cleaned, otherwise it may leak out. After opening, the filtrate must be stable. Be careful when removing the filter bag.

After removing the filter bag according to the relevant method, place the new filter bag in the filter bag. Due to equipment differences and certain differences, it is possible to try replacing the filter bag according to the installation instructions to ensure that the filter bag will not fall off after replacement.